Home > Computer Won 39 T > Desktop Won't Boot (Appears To Be Memory Issue)

Desktop Won't Boot (Appears To Be Memory Issue)

Contents

Walker FirminDec 27, 2014, 9:57 PM In the past I have taken ram out of my system and all it says is that no ram is installed, but I don't think Reply to smorizio TachyonParticleAug 18, 2016, 2:45 PM I tried booting using each stick of RAM in each of the two slots. This is the troubleshooting guide to follow if you're returned right back to the Startup Settings or ABO Screen on every attempt to enter Safe Mode, Last Known Good Configuration, and blue_suns, Jan 14, 2015 #8 Triple6 Rob Moderator Joined: Dec 26, 2002 Messages: 50,384 I'd get the single 4GB module and then you have a free slot left for a future

Tried everything. Because it has attracted low-quality or spam answers that had to be removed, posting an answer now requires 10 reputation on this site (the association bonus does not count). Since that method of fixing important Windows files is non-destructive, make certain that you've tried that before the completely destructive, last-resort clean install in this step.Tips & More InformationDid I miss My PC won't boot: Remove any USB drives or memory cards Assuming everything is ok with the power supply and screen, your computer may be getting stuck before it loads Windows.

Computer Won't Boot Windows 7

Steps 9 and 10 both involve more difficult and destructive solutions to Windows getting stuck at the Startup Settings or Advanced Boot Options menu. Sometimes the reason a PC won't boot is because hardware fails and there’s no easy fix. A BIOS misconfiguration could be the reason that Windows won't even start in Safe Mode.Important: If clearing the CMOS does fix your Windows startup problem, make sure any changes you make Check over the wire itself, as power supplies get beaten up, especially if you carry them everywhere.

Other benefits of registering an account are subscribing to topics and forums, creating a blog, and having no ads shown anywhere on the site. solved Asus M5A97 R2.0 wont boot up after installing new RAM memory solved Windows won't boot after laptop memory upgrade solved Computer won't boot past bios after graphics card driver installation See the notes in Step 3 about accessing these diagnostic areas.Windows XP & Me Users: Again, this troubleshooting option is not available to you. Windows 10 Won't Start All rights reserved.

This occurs when I put the new stick in alongside the old one, or by itself in either of the two DIMMs. I may try flashing the BIOS, but it may be a signal integrity problem. Advertisement blue_suns Thread Starter Joined: Jan 14, 2015 Messages: 4 Hello, So yesterday when I started up my computer it failed to boot. See How to Create a Windows 7 System Repair Disc or How to Create a Windows 10 or 8 Recovery Drive for tutorials.Windows XP & Me Users: This troubleshooting option is

You can then boot from this and attempt to fix the problem with Windows. Computer Won't Boot Up Black Screen If there is a faint image – maybe the Windows logon screen – then it’s likely that your screen’s inverter has failed. Walker FirminMar 16, 2015, 1:57 AM Im pretty sure it cant stop it from turning on but in the worst situation if it is a problem with the ram your computer Yellow light below power button comes on for a couple minutes.

Computer Won't Turn On

DDR3 RAM2Won't boot after inserting new RAM sticks0New RAM making computer restarts immediately0New RAM doesn't work with old RAM Hot Network Questions Lecturer in a course I'm TA'ing refuses to give http://www.pcadvisor.co.uk/how-to/laptop/how-fix-pc-that-wont-boot-3528959/ Taking out the ram and wiping it with a rubber fixes this temporarily but new ram is the best method. Computer Won't Boot Windows 7 Reply to TachyonParticle 5 answers Last reply Aug 23, 2016 Best Answer Aug 23, 2016 More about computer boot memory management failure smorizioAug 18, 2016, 5:46 AM mb need one ram Computer Won't Start Tech Reviews Tech News Tech How To Best Tech Reviews Tech Buying Advice Laptop Reviews PC Reviews Printer Reviews Smartphone Reviews Tablet Reviews Wearables Reviews Storage Reviews Antivirus Reviews Latest Deals

It is a Compaq Presario CQ5700Y running Windows 7 The RAM on the computer is a 2GB 2Rx8 PC3 10600U blue_suns, Jan 14, 2015 #1 Sponsor flavallee Frank Trusted http://magicnewspaper.com/computer-won-39-t/desktop-will-not-boot.html no beeps though. Show Ignored Content As Seen On Welcome to Tech Support Guy! I connected his monitor to my PC to see if it will POST in his home (suspected that my wall socket current was bad). Laptop Won't Boot

You can short the appropriate motherboard pins together (check which ones in your motherboard manual) to eliminate the power button from the equation. Back to top Back to Internal Hardware 0 user(s) are reading this topic 0 members, 0 guests, 0 anonymous users Reply to quoted postsClear BleepingComputer.com → Hardware → Internal Hardware Moniter says power saving mode and goes blank. http://magicnewspaper.com/computer-won-39-t/desktop-won-t-boot.html A System Restore will return all of those things to the state they were in at a time when your computer worked fine, which could solve your problem entirely.Windows 10 &

Tags: Desktop PCs, Laptops, Windows Share this article Share Tweet Send  Hi. Laptop Not Booting This can help illuminate the possibility of just a bad DIMM slot. Or is it something else?

is there any problem with my memory card o after adding new memory,computer wont boot Can't find your answer ?

If this does not work I would try them in another computer to attempt to find the real issue - the replacement sticks (unlikely, just like what psusi said), or the There are motherboards that will come with slots for both types of Ram... cloropad12-16-2011, 01:30 PMAlright thanks for the help, I'll get started on that. Windows 7 Won't Boot Black Screen more hot questions question feed about us tour help blog chat data legal privacy policy work here advertising info mobile contact us feedback Technology Life / Arts Culture / Recreation Science

This may not work, however, depending on what's causing your overall problem so you may have to boot to the install disc after all.Another Option for Windows 10, 8, or 7: Replacing an inverter isn’t too difficult if you’re handy with a screwdriver, but it’s crucial you buy the right replacement part. solved Computer won't boot up after I touched setting solved Computer Won't Restart--PXE-E61: Media test failure, check cable // PXE-M0F: Exiting Intel Boot Agent. What could be causing this?

Updated 25 October 2016 with general updates. Select Memory Diagnostics, which does not run in Windows. One of the most common PC power supply issues is that the PC will turn off unexpectedly rather than fail to boot up at all. Ask !

Contact the manufacturer and get an RMA started. Bad Stick of Ram? But that's what it says in its product specifications section. blue_suns, Jan 14, 2015 #4 Triple6 Rob Moderator Joined: Dec 26, 2002 Messages: 50,384 The stick may have failed, I don't suppose you have access to another computer with the same

a faulty RAM stick is one of the reasons that a computer not booting up. But at the very least, there is no way that with the information you supplied that you were able to put DDR2 and DDR3 interchangeably in the same slots. Newer Than: Search this thread only Search this forum only Display results as threads Useful Searches Recent Posts More... Ensure the primary drive is attached to a SATA port driven by the motherboard chipset, and not a separate controller.

I'm sorry for posting confusing information about the old RAM. If not, try this troubleshooting: Borrow a working monitor from another computer and try it in place of yours. After a couple of hours with another CPU and without the suspect RAM stick, the monitor turned off again. solved Computer won't boot without original ram stick solved Won't boot up with more than one ram stick Can't find your answer ?

As a guest, you can browse and view the various discussions in the forums, but can not create a new topic or reply to an existing one unless you are logged The computer failed to POST. I unplugged PC power cord and turned it on again. This site is completely free -- paid for by advertisers and donations.

Get the answer Dinosaur hunterSep 13, 2012, 9:56 AM I have changed the mother, but it is doing the axact same thing as before.