Home > Computer Won 39 T > [SOLVED] Computer Boot Up Problem.

[SOLVED] Computer Boot Up Problem.

Contents

I saw this on PC Advisor and thought you should see it too. And we even manually tried to place drivers on. Otherwise I don't see any reason why your system should not work. Add My Comment Cancel [-] AmyA4969 - 8 Jan 2017 5:10 PM Hi,I have a Toshiba satellite laptop that I tried to do a reset on. weblink

It was formerly Vista but for some reasons the owner did not like it and Installed XP in it, it worked fine for more than six months. Since it only had 2 beeps is that a bad sign? Power it on and now now monitor, mouse or keyboard. So I took out the 128's and left them out turned it on and ONLY 2 beeps sounded and then nothing. http://www.wikihow.com/Fix-a-PC-Which-Won't-Boot

Computer Won't Boot Windows 7

Then after a few tries it went back to no monitor, no USB Etc. I press F2 to go to the BIOS settings but nothing. You may or may not see the Windows splash screen before the blue screen appears.This kind of error is called a STOP error but is more commonly referred to as a

If you have one, the Windows DVD can be used, but otherwise you can download (using another computer – obviously) a rescue disc image and either burn it to a CD We respect your privacy and would never share your information. The only symptom is usually the simple fact that "nothing works" which isn't much to go on.Add to this the fact that whatever is causing your computer not to start could Computer Won't Turn On Nothing on the monitor, keyboard or mouse.

Report cpoluk- Feb 13, 2009 at 03:59 PM Reading what you said about finding out if the processor is good. Windows 7 Startup Repair Not Working I don't think is shouldn't be doing this with 38 percent memory free. It's such a nice country. click for more info Then re-install Windows.

This is and endless loop and I do not have a disk drive but from what I've read in the threads pertaining to this problem, it doesn't even matter because discs How To Fix Startup Repair Windows 7 Without Cd In some steps between, I got the message saying “checking media”, with two options, IPv4 and IPv6. Again, I took out the RAM, changed the RAM, took out all non essential cards, tried the onboard VGA instead of the PCI E, nothing I'm begginning to think that I If placing the memory card in another slot does not work then the problem lies with the memory card itself.

Windows 7 Startup Repair Not Working

Does it give the continuous beep sounds?

I can also run a disk called german police boot cd which loads fine & I get into the desktop only its XP pro on it. Computer Won't Boot Windows 7 plz help people???? Computer Won't Boot Up Black Screen This means disconnecting your graphics card, additional drives, PCI expansion cards, and extra RAM.

If you can see the coloured wires inside the black outer protection, it could be time to buy a new PSU. have a peek at these guys This goes for the power adapter you may be using for your tablet or laptop as well.How To Fix a Computer That Shows No Sign of PowerNote: Don't worry about the Perhaps the new motherboard does not support this processor. From that moment, my PC wont start anymore, not even a flashing screen, nor a beep. Computer Won't Start

Windows 10 reboot loop solutions As with other Windows OSes, a continually restarting Windows 10 operating system exhibits the same familiar BSOD -- the computer stuck in a reboot loop. If anything, it sounds like you’ve got some driver or hardware problems. The most effective of these is the deep reset, which temporarily halts power to the volatile memory on board all computers, thus resetting it to a factory fresh state. check over here Read More .

If you can’t get the Advanced Boot Options screen by hitting F8, you can also access the tools by booting from a System Recovery Disc, or the Windows installation disc. Computer Not Powering On Here’s how to boot from a USB drive How To Change The Boot Order On Your PC (So You Can Boot From USB) How To Change The Boot Order On Your Report justine0409- Jun 29, 2009 at 09:23 PM ive tried to pres the casp lock..

Put them back in and no monitor shows, just the test screen that says it is working properly.

DJ Akshay... Report Fran› DJ AKSHAY - Feb 6, 2009 at 02:34 PM I also have a very old gateway computer 1999-2000 almost the same problem with the power button. There is not a 4 pin hook up from the power supply to the MB. Windows 7 Boot Problems Flag as duplicate Thanks!

Check adaptor output specification on the adaptor itself then inform me. So I turned off and back on and this time it's reverted back to the frozen Motherboard page. You will be prompted to log in before you can start the repair process. 4 Select "Startup Repair". this content I mean in the new motherboard manual you will notice a range of compatible processor frequencies that are supported by the motherboard.

If a virus is causing the problem, use a rescue disc from an anti-virus provider as this will include scanning tools which can find and remove the malware. Restart one time more, I reach the bios and the it goes black again. set your bois that it boot from cdrom and secondly your hardrive. Turn off your PC.

We tried several times to boot in safe mode with no response. Startup repair may suggest performing a System restore, or you can select it from the main Repair menu. This unit is only a few months old and was shipped to me from a friend. Updated 25 October 2016 with general updates.