Home > Hard Drive > 2nd Hard Drive Not Recognized

2nd Hard Drive Not Recognized

Contents

When XP is installed with one hard drive, apparently the default is to not expect a second drive to be added! If you believe this post is offensive or violates the CNET Forums' Usage policies, you can report it below (this will not automatically remove the post). Take the 2nd HDD and connect it to a different computer to see if it works OK. I have a blank IDE Drive that I installed and it wasn't recognized until I went into disk managememnt, put it online, and formatted. http://magicnewspaper.com/hard-drive/new-hard-drive-not-recognized.html

I think data is not corrupted but some reading head might be damaged. Any ideas on how to get Disk Management to recognized the2nd hard drive?Pat. 0 0 0 pepe999 Regents Professor Posts: 4,296 Member Since: ‎03-09-2010 Message 2 of 2 (3,261 Views) Report Control Panel > Administrative Tools > Disk Management. How do I get windows to access the drive????

Secondary Hard Drive Not Detected Windows 10

Family photos are back! Read More. When you installed the old drive, your BIOS probably decided that that was the first drive--the one that boots.

If you touch the side of the drive you should feel a slight vibration. Pingback: Fix: CONFIG_LIST_FAILED error on Windows 10() pigeont this was helpful Shashi Ponraja Worked brilliantly - the new hard drive just needed to be formatted for use 🙂 Don Green So I thought it might need to be partitioned (even a partition of one, which shouldn't even be called a partition), but couldn't find where to do it. 2nd Hard Drive Not Showing Up Windows 10 If you do, use that IDE and power cable and jumper setting.

I can't tell you exactly how to do this because it varies with different models, but when you boot your PC, one of the first things you should see is a Second Hard Drive Not Showing Up In Disk Management Jhon amilbangsaMar 15, 2014, 3:01 AM dear sir, i believed that you are right but i have only one hard disk western digital 160 GB for so many years i was My C: drive with the operating system on it is good. http://www.tomshardware.com/forum/270832-32-sata-hard-drive-detected-bios-setup See How to make good use of an old hard drive for details.

If the power is connected properly, but SATA is not, the drive will power up and spin, but it will not be visible to the computer. Windows Not Detecting Hard Drive But Bios Does Either buy an external IDE hard drive case ($25-75), or simply open up your case, set the drives jumpers to slave or cable select, disconnect your cdrom drive, connect those cables do you have any more ideas. Check the Checklist and Click Ok , , , =D - [email protected]! - Report zzzzzzz- Oct 12, 2012 at 11:43 PM Thanks for the tip, this worked great!

Second Hard Drive Not Showing Up In Disk Management

If you do, when you are finished come back here and find the remainder shown as "Unallocated Space". see this Showing results for  Search instead for  Do you mean  or Post new question Post new question Question Reply Topic Options Subscribe Mark Topic as New Mark Topic as Read Float this Secondary Hard Drive Not Detected Windows 10 Cheers, I wanted to praise your willingness to help. Second Hard Disk Not Detected Windows 7 The drive is not detected, therefore you can do nothing with it!

You Might Like Shop Tech Products at Amazon PCWorld PCWorld helps you navigate the PC ecosystem this page Additionally, older computers may require BIOS/CMOS settings adjustments to enable or disable hard drives. If you simply want to increase your internal storage, my advice below should help you. Report NyteFyre22- Jan 3, 2009 at 05:20 PM diggleydog Thank you so much, I was about ready to pull my hair out because I could not figure out how to make Secondary Hard Drive Not Detected In Bios

Your drive may simply need to be partitioned and set up. Also change the SATA cable from it to your MB.That could fix the problemIf the 2nd HDD is recognized in the BIOS, Boot up to windows and go to the Device That way, Primary boot will be your sata drive your old hard drive will take your dvdrom's drive letter (D) Ask a question Member requests are more likely to be responded get redirected here So, we're going to change the drive letter and hopefully, the hard disk will show up again.

Its working as you said i feel running vibration when I touch the top. Windows 10 Not Recognizing External Hard Drive About CNET Privacy Policy Ad Choice Terms of Use Mobile User Agreement Help Center Discussion Boards Open Menu Discussion Boards Open Menu Welcome to the Forum! IT COULD!!!!

I ended up installing the new drive into a external hard drive enclosure and informatted the new drive, then reinstalled it back into the Envy and Disk Management still does not

References (7) PCWorld Documents: Installing SATA Hard DrivesAOMEI Tech Co., Ltd.: Windows 7 Disk Management & Partition Magic Windows 7 Alternative: Windows 7 Disk Management OverviewKingston Support: Frequently Asked QuestionsSanDisk: Difference You'll have a choice of how big it should be and most likely want to use all the drive in one volume. (You can use only part of the space. Make sense? Hard Drive Not Showing Up In Disk Management Windows 10 To check to see if this is the cause of the BIOS not detecting the hard drive, follow these steps: Power off the computer.Open the computer case and remove the data

My Envy already had a 256gb msata drive that is my boot drive C:, and a 1tb hard drive in bay 1 that holds my data. what do I do? Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content ‎08-14-2013 06:12 PM I installed a 2nd 1tb hard drive into the http://magicnewspaper.com/hard-drive/can-t-get-hard-drive-recognized.html penchalJul 16, 2011, 3:52 PM Dear Sir,I tried by connecting to others computer MB even though it is not detecting.

I tested my HDD. John_vankirk,I checked by your way. I want to KEEP the data already on the drive.