Home > Power Supply > Computer Not Turning On After Putting In New Components?

Computer Not Turning On After Putting In New Components?

Contents

damasvaraOct 7, 2010, 2:58 PM Why not use the standard method of PC installation? Please note though that it won't provide a 100% surefire way of fixing things as there is none.Instead, it will look at basic diagnostic options that may help understand what is I think it is trying to tell me something. Turn off the power supply with the IO switch.2.

If you're using the same case, check if there's a short between the case and the motherboard. its 4.0 Paul NZDec 6, 2014, 5:35 AM Ok, its not a BIOS prob then its something you've missed outSo you've connected the ATX 12v the CPU fan and 24 pin?If That should leave two pins to the left of the switch and an empty slot to the right of the switch.From there:1. by VAPCMD / February 5, 2010 2:20 AM PST In reply to: Changed power supply but pc still does not power up your favorite search engine will produce many.VAPCMD Flag Permalink http://www.tomshardware.com/forum/291633-28-installed-motherboard-turning

Installed New Power Supply Computer Won't Turn On

That's why, from the very beginning (set the way back machine to 1981) we figured a lithium battery, like the CR025, could probably keep the CMOS alive for 2-3 years... Try to borrow one RAM module (any size, doesn't have to be 4GB) and replace the RAM module in your motherboard with it. You didn't get a speaker with your case?

seeprime April 24, 2016 at 11:24 pm # A 500 watt power supply doesn't pull 500 watts just from being on. If you leave one out, those dots/circuits aren't making proper ground potential, this will show up in the weirdest ways somewhere down the line. If not, check these possibilities: Your power supply is properly connected to your motherboard Your CPU is properly installed along with the CPU cooling source (fan) Sounds like your RAM is New Power Supply Turns On Then Off Is the power cord plugged into a wall outlet and into the power supply?

Then not at all. Power Supply Works Computer Wont Turn On Also, check that all internal wires are properly shielded with a rubber or plastic exterior. I'm not sure what else to try and any advice is welcome. Plug the CPU fan into a motherboard fan header.4.

Again I put the old one in and the computer does the same thing as stated above. Psu Wont Turn On Without Motherboard Proffitt Forum moderator / February 5, 2010 11:29 AM PST In reply to: Good thought - the power on switch. The system will not boot without it.I always breadboard a new build. Why does Lou scold Willy Mays Hayes after he makes a catch?

Power Supply Works Computer Wont Turn On

How much should you donate? http://www.tomshardware.com/answers/id-1682724/power-supply-installed-computer-boot.html This will solve many issues, particularly those that crop up when you're installing a new motherboard for the first time. Installed New Power Supply Computer Won't Turn On sp3nny_88Oct 7, 2010, 1:56 PM Hey guys, i recently installed a new motherboard and connected everything except the LED's, ive tried to jump start it by touching the two "PWR SW" New Psu No Power Flag Permalink This was helpful (0) Collapse - Yes a dead CMOS battery by R.

Then why do most desktop PC's need a PSU of 500W or bigger? 500W, that's like having all the light bulbs in the house turned on!There's only one computing device that Now when I try to turn it on, I get no response. All Rights Reserved Tom's Hardware Guide ™ Ad choices Digital Trends Home > Computing > Five possible reasons why your new motherboard… Five possible reasons why your new motherboard isn't working, Why is Trump's omission of an explicit mention of Jews from the holocaust memorial a big deal? Replaced Psu Still No Power

Also, make sure the power connection is working by testing it with another electronic device.PCs have a power on/off switch on the back usually. solved Installed new parts and now my pc wont boot. Is this the point which I just have to take it in to a professional (best buy/micro center, etc) to have it analyzed or are there any other things a willing CPU needs this signal to boot.You can turn on the PSU by completely disconnecting the PSU and using a paperclip or jumper wire to short the green wire to one of

Being somewhat of a hardware guy, I would suggest a few more diagnostics, but before I do, let's address your case power switch. New Psu Not Turning On When I try to turn it on all the lights and fans work for about half a second and then stop. About CNET Privacy Policy Ad Choice Terms of Use Mobile User Agreement Help Center

Did Captain Needa die in The Empire Strikes Back?

Good to have one on hand. Flag Permalink This was helpful (0) Collapse - No power by Marysvilleman / October 11, 2015 6:30 PM PDT In reply to: Changed power supply but computerr still won't start. Improper seating of the video card and RAM are the most likely sources of your problems, because issues in those areas are easy to overlook. Rma Power Supply Matters are made worse by the fact that the front power button’s connection is part of a cluster of connections, so accidentally connecting power to pins that control the reset button

Reply Your Name April 22, 2016 at 3:25 pm # First thing I try with a laptop that won't turn on. Find the power switch cable on the case. Think through everything you have done in the setup, even the heat sink and thermal paste. http://magicnewspaper.com/power-supply/turning-on-psu-turns-on-pc.html Did the White House fabricate an Iranian attack on the American Navy?

Reply Joey Spinosa April 22, 2016 at 8:35 pm # One other tid-bit to go along with the motherboard screws... Actually, going way, way back to my very first laptop, a Zenith Z-180 with 640KB of RAM and a massive 20MB hard drive ;-), the internal AC power adapter eventually burned It's very cool looking. When I came back the pc wouldent power on.

If it starts with both modules, you have a bad slot B. by Fredxxxxx / February 5, 2010 2:31 PM PST In reply to: Just tested Power Supply Can you see an LED on the motherboard when you turn on the power? Discussion topics include choosing a processor, installing hard drives, adding RAM, upgrading video cards, sound cards, DVD drives, Blu-ray drives, PSU, and much more.Real-Time ActivityMy Tracked DiscussionsFAQsPoliciesModerators General discussion Changed power Those dots, those circuit ground points, are also why you NEED to use a screw (and it's anchor) for EVERY hole your motherboard has to the chassis.

Nothing happened to the power supply, but the lights in my house flickered (maybe just a coincidence). All I had to do was put it in the right place to have the system boot up again without any further issues.Once you are done with the checking, plug the Jebsus. Can't find your answer ?

There is also a yellow LED that shows the RAM is okay. BIOS hardware incompatibility Motherboards ship from the factory with a BIOS or UEFI operating system that can handle modern hardware, but any hardware released after it ships is not guaranteed to Which one is it?2Computer crashing about 20sec into booting (even in BIOS). Plug in and it should fire back up!

no fan spins or beep noises. Don't miss our future articles! In the absence of a single short beep, they also do not indicate that the system is booting.At this point, you can sort of check the PSU. Click the power button on the case.What do you see?

Reply inab April 23, 2016 at 10:45 am # Another funny thing i've seen a long time ago : There was blown up capacitors on the mb (on a old motherboard That should leave two pins to the left of the switch and an empty slot to the right of the switch.From there:1.