Home > Power Supply > Do I Need Another Power Supply For This Mobo?

Do I Need Another Power Supply For This Mobo?

Contents

Flag as... Older PSUs (very old) may require a load on the +5V to produce 12V.

I have never seen a PSU without a power switch before. Tell them that you believe repair should be fair, affordable, and accessible. I've run a second psu by simply running a wire from one psu's green PS_ON pin to the second's and another wire from a ground pin on the first to ground on the

iFixit: Repair Manual Official App Free – Google Play Install Select a Language: 中文 日本語 Deutsch English Español Français Italiano Nederlands Português Русский язык Türkçe Machine translation Help Translate iFixit Close Iniciar sesión Compartir Más Denunciar ¿Quieres informar del vídeo? by FixedHDD in computers Download 3 Steps Share Favorite I Made it! I just ran a wire between one green port and one black port, and the power supply works like a champ.

Great instructable. their explanation

How To Connect Power Supply To Motherboard

Will it have the power required? Take Action That worked without causing any great fires or other calamities? I never bought into the "low power" idea so I'm going to rundown some of the other solutions users have posted and abandon the aux power idea.

Connect your graphics card. Opening it up and looking up the data sheets / specs. Take Action It's time to speak out for your right to repair Dear Washingtonians, Washington has a chance to become the first state in the nation to pass "Fair Repair" legislation. Power Supply To Motherboard Diagram Scott Macmillan December 20, 2012 at 5:38 pm Thanks for the article.I think I will be buying a new one and upgrading rather than using the old one.

You could use a power resistor of the appropriate size.

The easiest thing to use to test a lot of devices that need a 'load' connected in order to operate, is a All three brands of those units are rated 13.8V and they were all used to power equipment rated at 12V. Read More . Anonymous Yes, you're right about the 12V and 5V requirements.

Most ATA hard drives draw about 6-7W, dependent on the maker... (as long as nothing is connected to the IDE socket, powering up/down a hard drive will not delete data.) The How To Install Power Supply Cables Scott Waschlerner - 12/24/2015 Reply Add Comment 1024 View Statistics: Past 24 Hours: 21 Past 7 Days: 100 Past 30 Days: 365 All Time: 8,698 25,131 Free Manuals 95,380 Solutions 7,330 Plug the 24-pin power connector into your motherboard first, then go for the 4 or 8-pin CPU power connector. Iniciar sesión 374 57 ¿No te gusta este vídeo?

  • Sometimes they have three or even four 12 volt rails.
  • Flag as...
  • The fans are installed in a plastic case so it's easy enough to mount them to the open side of the tower.
  • There's a helluva lot of hipe but strangely I couldn't find anyone that used one?
  • The Fair Repair Act guarantees our right to repair digital equipment like computers, refrigerators, cell phones and tractors.

How To Install A Power Supply In A Desktop

The power supplies I want to use were used by the old mobile phones to power the phones or to recharge the battery packs issued with the phones. Flag as... How To Connect Power Supply To Motherboard BTW... Connect Power Button To Motherboard There was no reason to splice a ground between them because I checked and my Antec PSU's ground connections went through to the chassis ground and both PSU's were connected firmly to the chassis.

Orient the cable connector properly relative to the motherboard connector, and press the cable connector into place until the plastic tab locks, as shown in Figure 16-15. If your power supply main power cable and motherboard main power connector both have the same number of pins then they'll (of course) fit together just fine. now i have to admit, i have no idea what will happen if either of the 24 pin or 4 pin connectors are removed while the other is still powering. He wasn't sure if he was Peter Paul, or Paul, Peter but it wasn't important to him and he enjoyed the confusion it caused the military. How To Install Power Supply To Motherboard

Leon Stacey 45.373 visualizaciones 4:00 Testing the PC's PSU - Duración: 22:15. If you can’t, then the power supply may be inserted incorrectly. mea culpa………. http://magicnewspaper.com/power-supply/possible-bad-mobo-or-power-supply.html Apr 9, 2012 #10 melkor849 TS Rookie Topic Starter It worked!

Tell them that you want the right to repair your purchases. How To Replace A Power Supply Manufacturers don’t want a Fair Repair bill. Knowing how to fix simple issues like a dead power supply is an even better way to get the most out of your money and to avoid splurging on a whole

Find out who represents you in Kansas' legislature.

If you're fussy about the appearance I wouldn't recommend my method. The motherboard main power cables The ATX standard has two different versions of the main power cable: the original 20 pin cable, and the the newer 24 pin cable. You’ll find even more information including the truth about efficiency ratings and details on how to buy the right unit for your PC. How To Remove A Power Supply mechrocktech 35.018 visualizaciones 22:21 How to connect front panel connectors to the motherboard - Duración: 9:57.

How to install an Intel or AMD CPU in... Apr 11, 2012 #11 dmill89 TS Guru Posts: 475 melkor849 said: ↑ It worked! Find out who represents you in the Nebraska legislature. As you remove each cable, pull it out of the case to avoid tangling them with the other cables.

So i connected both the fan and the 3.5" hdd and......There it is. The add2psu is a new AND niche product so there won't be too many reviews just yet. Take Action It's time to speak out for your right to repair Dear Kansans, Kansas has a chance to become the first state in the nation to pass "Fair Repair" legislation. Añadir a Cargando listas de reproducción...

Apr 9, 2012 #4 dmill89 TS Guru Posts: 475 Blkfx1 said: ↑ Your 550W PSU should run that system just fine. Figure 16-13: Secure the power supply with the four screws provided The next step in assembling the system is to connect the power cables from the power supply to the motherboard. Test all components on your computer before returning the side panel and reinstalling the outer screws. Cargando...

And it did help me. If you hear a beep and nothing happens, then something inside is not connected correctly, or the power supply is not providing enough power to your components.[1] Community Q&A Search Add I happened to see your page so i tried with an old psu that i wasn't using...I was dissapointed at first because the psu started for a moment and then it