Home > Power Supply > Does PSU Need To Be Connected To The Motherboard To Do Something?

Does PSU Need To Be Connected To The Motherboard To Do Something?

Contents

When in doubt, read the manual, and remember to connect your motherboard and graphics card to your power supply! Turn off connected devices.

2. Could someone please help me? TigerDirect 389.506 visualizaciones 10:06 Troubleshooting a desktop computer: PSU or Motherboard? - Duración: 41:16.

What can I do? Warnings Remember that all power supplies contain various capacitors inside of them that retain power even after it has been turned off. Laurie Potter 187.984 visualizaciones 11:54 Testing the PC's PSU - Duración: 22:15. That ckt latches the green wire connection to ground - the same as what you do with the short from green to black.

How To Connect Power Supply To Motherboard

A large cooler can make it difficult to insert RAM into the memory slots after the fact. The worse place for computer advice ever. The spec sheet says: 1 x CPU Fan connector(s) (4 -pin)2 x Chassis Fan connector(s) (4 -pin)1 x Power Fan connector(s) (3 -pin)Doesn't that mean there is a PWR_FAN port? In general, power connections are designed to be hard to put in wrong, so if it isn't going in, chances are something's turned wrong.

If there are obstructions when removing the power supply, (e.g. This is the largest connector on the power supply. So I tried my old PC PSU and now I can charge @ 3 A instead of 2 A.

wow so my old brain says add a switch use my old 300w How To Install Power Supply To Motherboard There may be tie straps in the case, which may need to be cut.

Warning: We do not recommend trying this unless you have experience with internal computer components and understand electricity. Does it matter which I cable I connect? Make sure that the wattage of the power supply is sufficient for the hardware you have installed.

Likely as part of a chain.Your fans are either powered off your motherboard with 3 narrow pins at 0.1" spacing, or with a big 4-pin peripheral connector, with 2x black, red,

Esta función no está disponible en este momento. Smps Connection Diagram Follow it to the 20 or 24pin ATX plug. solved Where do all the cables connect to? Control is based only on a temperature measurement sensor for each fan port.

  1. All things are plugged in except graphics card.
  2. Flag as duplicate Thanks!
  3. Following the installation instructions on a multihundred-dollar investment is a must, even if you’re a DIY vet and you know what you’re doing.
  4. Maybe in some cases you want to test an old ... 1 Step 1: Search!Just look after the green wire in the cable tree from the PSU.
  5. For now, I'll be using the stock fan that comes with the 3570K.
  6. Subscribe ▲ Learn more about PCWorld's Digital Editions    🔎 Home News Reviews How-To Video Business Laptops Tablets Phones Hardware Security Software Gadgets Subscribe Resources PCs Phones Printers Ultrabooks
  7. Go ahead and plug your fans into your motherboard, advice like that is what you see in youtube comments.
  8. Answer this question Flag as...
  9. Laying the case on its side will typically provide the best access to the power supply housing.
  10. Vuelve a intentarlo más tarde.

Connect Power Button To Motherboard

They MAY have their own power wires so that this one fan has more than 2 wires from it to its connector. http://www.tomshardware.com/answers/id-2736447/valid-molex-pin-adapter.html Ask a new question Read More Power Supplies Cooler Master Cases Motherboards Components Related Resources solved Connecting Case fans to Motherboard and PSU questions solved P7P55D-E EVO, PSU or Motherboard How To Connect Power Supply To Motherboard It will need to provide enough power so that all of the components can function properly. Power Supply To Motherboard Diagram I did not have it plugged in on my old power supply though.

So even with an adapter to allow connection of the Ground and +12VDC lines to a mobo port, there is no fan speed readout possible. http://magicnewspaper.com/power-supply/can-a-bad-motherboard-fry-the-psu.html Credit: Thomas Ryan More like this How to install a graphics card How to overclock your graphics card and make PC games run faster for free 7 things I learned once But more often than not, boxed, pre-built desktops ship with the cheapest power supplies that meet the criteria of their product warranties. How to build a PC Previous Next How to build a PC: A step-by-step, comprehensive guide Currently reading How to avoid common PC building mistakes How to install (or replace) a Connecting Smps To Motherboard And Other Devices

Make sure that any fans on the power supply are not blocked, and that you can screw it in from the back with all four screws. Most drives use SATA power connectors, which are thin plugs. Make sure that your power supply can accommodate everything that you need to connect. http://magicnewspaper.com/power-supply/psu-or-motherboard.html Some of the more powerful video cards require two PCI-E connectors.

Can't find your answer ? How To Install A Power Supply In A Desktop Yes No Cookies make wikiHow better. Fixed HDD probably isn't even monitoring this any more but I send him (or her) my thanks from California.

solved Will all fans, fan control, usb ports etc on the case work with this psu and motherboard?

By continuing to use our site, you agree to our cookie policy. Also, every psu has a main switch on the back, no need to jank the plug, even if you just short these pins with a wire ... From what I understood, I can connect a chassis fan to it, but wouldn't offer any speed control...is that right?Thanks! 9 answers Last reply Jul 26, 2015 More about case fans Motherboard Power Supply Connectors rawanabusalmanFeb 13, 2013, 6:13 AM Hey guys,I recently bought the Cooler Master CM 690 II Advanced case (CM 690 II Advanced (USB 3.0 version) - Cooler Master).Receiving my Asus P8Z77-V LE

Once the power supply is secured, you can start wiring the interior of the computer. Check twice, cut once before removing any tie strap restraints. Añadir a ¿Quieres volver a verlo más tarde? There is a small chip inside the fan motor that uses this signal to control how much of the +12VDC supply actually does flow through the motor, thus controlling its speed.

Buying a boxed, pre-built desktop is a great way to pick up a computer on the cheap. How to install an Intel or AMD CPU in... Cargando... JoshPCsAndTech 29.340 visualizaciones 3:44 Learn how to assemble motherboard - Duración: 3:38.

Inicia sesión para que tengamos en cuenta tu opinión. This saved my equipment.

Do I plug in the ATX before or after installing the wire into the green and black sockets?

Unless the part of the wire you are touching is insulated, The PSU does its own fan speed control internally. A 4-pin fan also uses 4 wires, but they are VERY different from the Molex 8981 power supply system.

Aside from a few capitalization mistakes and one spelling mistake, your English spelling is also quite good, and is better than that of a significant number of Americans.

Vielen dank! More resources See also solved Connecting Sata Power Cable issue - daisy chained sata power getting in the way. That means the fans can only run at full speed. ONE of the case fans also has blue LED lights, presumably intended for the front.

Ich verstand, kein problem.

Quite simple ...