Home > Unable To > Unable To Access Certain Websites: "destination Host Unreachable"?

Unable To Access Certain Websites: "destination Host Unreachable"?

Contents

It also seems to be intermittent. Cheers. If you have DHCP enabled, open the command prompt, type ipconfig /release. Hooray for Conforming! http://magicnewspaper.com/unable-to/unable-to-access-websites.html

When you ping to a host in the same subnet, your computer sends an ARP request for the MAC address of the destination host. When I ping the Linksys from the pfSense box I keep getting A RANDOM MIX OF "Destination Host Unreachable", timeouts and fast normal responses (3ms). Try to ping the destination again. Networking Forum powered by InfoSec Insitute Register| Login Login Username: Password: Log me on automatically each visit Register Blog Register Login Board index Other Technologies Home Networking Unable to access some

Can't Ping Website But Can Browse To It

Some laptops have an external wifi switch and even if you turn that off you may still be able to receive but can only transmit at very low power. Have you disabled the firewall and check for the issue ? 3:41 AM Sam said... C:\corenetworkz>ping 4.2.2.2 Pinging 4.2.2.2 with 32 bytes of data: Destination host unreachable. I know that some virus programs or firewall programs just decide that THEY don't approve of certain sites and they block access to them.

From 192.168.0.14 icmp_seq=2 Destination Host Unreachable From 192.168.0.14 icmp_seq=3 Destination Host Unreachable From 192.168.0.14 icmp_seq=4 Destination Host Unreachable --- 24.29.103.16 ping statistics --- 4 packets transmitted, 0 received, +3 errors, 100% The following example shows a set of two pings, each 1450 bytes in size, that wait two seconds (2000 milliseconds) for a response before timing out. Quote: wlan0 Link encap:Ethernet HWaddr 00:26:5E:FF:81:73 inet addr:192.168.0.14 Bcast:192.168.0.255 Mask:255.255.255.0 inet6 addr: fe80::226:5eff:feff:8173/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:1900 errors:0 dropped:0 overruns:0 frame:0 TX packets:21 errors:0 dropped:0 overruns:0 Traceroute networking ping icmp share edited Sep 26 '16 at 5:31 kiamlaluno 15.9k125179 asked Mar 1 '14 at 5:36 Suresh Kumar Veluswamy 2,1141921 add a comment| 4 Answers 4 active oldest votes

Thank you in advance. How is that possible? 10:01 PM Admin said... Firewalls are disabled. Can I trust a significant result of a t-test if the sample size is small?

Also, check your HOSTS file and make sure something strange isn't going on there. Icmp While Tracert does not record the address of the last hop or the path that the packet followed on the return path, it might show that the packet made it to Does anyone have any ideas as to what the issue is? I'm very clueless, so if there is something you recommend i do, please literally spell it out.

Ping Request Could Not Find Host

Privacy Policy | Term of Use | Posting Guidelines | Archive | Contact Us | Founding MembersPowered by vBulletin® Copyright ©2000 - 2012, vBulletin Solutions, Inc. You’ll be auto redirected in 1 second. Can't Ping Website But Can Browse To It Finally, check to see that the default gateway is a router, not just a host, and that it is enabled to forward IP datagrams. Tracert Outstanding and simple article.

You should get the name and the ip address of the site in the command prompt window. 4. Lykouragh on July 20100 Uncle_Balsamic Registered User regular July 2010 edited July 2010 Cheers guys. Test Network Connection with Ping and PathPing Ping is a tool that helps to verify IP-level connectivity; PathPing is a tool that detects packet loss over multiple-hop trips. Could the V-22 Osprey be used as a close air support platform? Flush Dns

Disabling power management had no effect. All rights reserved. The gateway address must be on the same network as the local host; if not, no messages from the host computer can be forwarded to any location outside the local network. ati radeon r9 390 8gb not working...

Yes No Do you like the page design? Dhcp This documentation is archived and is not being maintained. Don't think it is a firewall, just doesn't know how to route to that ip...

Thread Status: Not open for further replies.

How to deal with a employer who refuses to allow attribution in software Construct the natural numbers with sets Is there anything that functionally prevents a US President from switching parties? Also, try defaulting your router. ping < IP address of default gateway > Ping the IP address of a remote host to verify that you can communicate through a router. I think this error is something with my Firewall.

My concern is that you seem to have a very poor wifi connection for some reason. Then type ipconfig /renew. You can increase the TTL using the -i switch, up to a maximum of 255 links. http://magicnewspaper.com/unable-to/unable-to-host-any-services.html It means the Packet send from your computer reached the destination network successfully but the remote gateway failed to find the destination host.

Have you tested this on the wired connection (ping 192.168.0.1) ? Last edited by stevea; 22nd February 2012 at 11:14 AM. #13 22nd February 2012, 11:45 AM ishikKayabas Offline Registered User Join Date: Feb 2012 Location: New York City If the host does not exit, you will get destination host unreachable message. Everything from your router should go to whatever your gateway is.

I have connected a pfSense box on WAN, directly to a simple Linksys router on LAN. Anyway it just disappeared from my computer without doing any. I can access the internet using a wired connection, however. pathping < IP address of remote host > Note If your local address is returned as 169.254.y.z, you have been assigned an IP address by the Automatic Private IP Addressing (APIPA)

Also, the problem exists either on my computer or my router, as using an online utility, such as http://network-tools.com/ works, as does pinging from my router. Post a reply 3 posts Page 1 of 1 sb3700 New Member Posts: 1 Joined: Tue Dec 02, 2008 6:56 pm Unable to access some websites: destination host unreachable Tue Dec All firewalls are disabled. Get the weekly newsletter!

Sometimes windows updates (especially having to do with internet explorer) messes with our settings without our knowledge. Join Us! So now my iptables -L output is: Code: Chain INPUT (policy ACCEPT) target prot opt source destination ACCEPT all -- anywhere anywhere state RELATED,ESTABLISHED ACCEPT icmp -- anywhere anywhere ACCEPT all What was the first piece of software to be called an engine?

Now only I understand the real cause of this. Most often, it means that a route back to the sending host has failed.